地板常见问题

新西兰地板

新西兰买地板找FLOORCO,专业地板供应商!

大家在木地板的使用过程中有时会遇到地板开裂起拱变形的问题,今天小编就给大家分析一下出现问题的原因以及相应的解决方案,让大家之后在遇到此类问题时不再烦恼。

新西兰地板

问题一:湿胀起拱

原因分析

1. 长期连续阴雨,未排出湿气

2. 房内长期不通风,未排出湿气

3. 木地板被水浸泡

4. 地板底层地面含水率较高

5. 未留地板伸缩缝,造成无空间挤压

6. 地板单向超过8米未隔断,造成单个面积较大

预防措施

经常开窗通风,并严格按规定预留伸缩缝、做隔断。

解决方案

视情况采取部分重铺方案,或者全部拆开重铺,并调整隔断和预留伸缩缝。

问题二:干缩离缝

原因分析

1. 房间较长时间关闭,无潮湿空气补充,室内空气干燥

2. 在潮湿天气铺装时相邻板块间铺装间隙过大,遇干燥天气时,出现更大干缩离缝

3. 气候连续高温干燥等不正常气候环境,木地板解湿过快,未采取增湿措施

4. 阳光曝晒,长期吹风等不正常环境因素,造成木地板过度解湿干缩

预防措施

木地板相邻板块伸缝间计算并掌握施工时气候条件,适当预留伸缩缝;防太阳曝晒,不宜长期关闭门窗不通风,或局部集中吹风。

解决方案

等待一段时间,等木地板的含水率与空气中的相对湿度相平衡后,单块更换,或者全部拆开重铺,按要求设置相邻板块伸缩缝。

问题三:地板开裂

原因分析

1. 太阳曝晒或长期风吹,出现木地板出现干缩现象

2. 木地板受潮膨胀,含水率增大,出现湿胀现象

3. 气候变化大时,木地板含水率过大或过低,木地板出现干缩或湿胀

预防措施

选择质量好的生产企业的木地板,其弹性、耐磨性、漆膜的附着力均能得到保证。

解决方案

少量的漆膜开裂,可进行补漆修复;如单块木地板漆膜开裂且长度较长,可单块更换木地板;如果大面积漆膜开裂,可磨平后重新油漆。

问题四:翘弯变形

原因分析

1. 地板被水浸泡过

2. 地板底层地面含水率过高

3. 未做正常防水防潮处理

预防措施

混凝土基层须达到含水率要求后方能施工;含水率超标时必须铺装防潮隔离层,且防潮隔离层应做到整体密封。

解决方案

对变形严重的木地板予以更换,对变形不严重的部分,拆除周边木板排出湿气。

问题五:声响

原因分析

1.遇潮湿或干燥变形

2.安装后某处被卡住

3.地面平整度未达到标准

预防措施

切割所有边角,并尽可能留出最大的伸缩缝隙,尽最大可能将地面做的平整,使用窗帘和定期使用抽湿机。

解决方案

请注意,无降噪技术的地板发生响声十分正常的。没有任何办法可以解决悬浮式安装(Floating)所产生声响,发生声响收到天气空气环境玻璃等等因素,因此发生声响的面积位置既然不同。但FLOORCO仍然有办法可以短暂少量解决地板声响,即使用WD40.

新西兰地板

Flooring Issues?The common problems in the flooring use process.

Sometimes, you may encounter the problem of floor cracking and arch deformation. Today, we will analyze the reasons for these problems and the corresponding solutions.

WOOD FLOORING ISSUES or Problem

LAMINATE FLOORING ISSUES or Problem

SPC FLOORING ISSUES or Problem

Problem 1: Wet swelling and arch

Cause Analysis

1. Long-term continuous rain without discharging moisture

2. The room is not ventilated for a long time, and no moisture is discharged

3. The wooden floor , laminate flooring is soaked in water. The issues is about flooring warping.

4. The moisture content of the ground floor is higher, the issues is about flooring cracking anywhere.

5. No floor expansion joints are left, resulting in no space to squeeze

6. The floor is not separated more than 8 meters in one direction, resulting in a large single area. The issues about flooring moving much.

7.The SPC flooring laying down Decking or plywood, the wood subfloors moving or expansion flooring make click system gap or warping.

Precaution

Open windows frequently for ventilation, and reserve expansion joints and partitions in accordance with regulations.

Solution

Depending on the situation, reinstall part of flooring, or whole flooring completely, and adjust the partitions and reserve expansion joints.

Problem 2: Dry shrinkage

Cause Analysis

1. The room is closed for a long time, and the indoor air is dry

2. The gap between plates is too large in wet weather, and in dry weather, there will be more dry shrinkage

3. Abnormal climate conditions such as continuous high temperature and dry weather, the wooden floor, laminate flooring or SPC flooring dehumidify too quickly, and no humidification measures are taken

4. Abnormal environmental factors such as sun exposure and long-term blowing cause excessive dehumidification and shrinkage of the wooden floor

Precaution

Reserve expansion joints properly depending on the different climate; prevent sun exposure, it is not suitable to close the doors and windows for a long time without ventilation, or concentrated blowing.

The common issues in flooring.

Solution

Wait for a period of time. After the moisture content of the wooden floor and laminate flooring balances with the relative humidity in the air, replace it in a single piece, or replace the whole flooring, and set the expansion joints of plates as required.